Basic Laundry Cycle Quiz! Test
Washing of clothes and textiles with the help of a washing machine or hands refers to 'Laundry,' which is done in a room often called a laundry room. It has been a part of history since humans started wearing clothes. Nowadays, it's common in every home. This quiz will test your basic knowledge about the laundry cycle. Let's try it out. All the best!
- 1.
During the wash cycle, an optical step is to add a high-alkaline ________________ product.
- A.
Fabric softner
- B.
Sizing
- C.
Bleaching
- D.
Break
Correct Answer
D. BreakExplanation
During the wash cycle, an optical step is to add a high-alkaline break product. This suggests that the purpose of adding this product is to interrupt or stop the washing process temporarily. The high-alkaline nature of the break product may help in removing tough stains or dirt from the fabric. It could also be used to neutralize any remaining chemicals or residues from previous steps in the wash cycle.Rate this question:
-
- 2.
Which of the following is the last step in the wash cycle of a load of laundry?
- A.
Extract
- B.
Break
- C.
Flush
- D.
Rinse
Correct Answer
A. ExtractExplanation
The last step in the wash cycle of a load of laundry is "Extract." Extract refers to the process of removing excess water from the clothes after they have been rinsed. This is typically done by spinning the drum of the washing machine at a high speed, causing the water to be forced out of the clothes and drained away. Extracting the water helps to shorten the drying time and leaves the clothes damp rather than soaking wet, making them easier to handle and dry efficiently.Rate this question:
-
- 3.
Ninety percent occupancy for the past three weeks has strained the capacity of the on-premises laundry at the Permanent Press Hotel. Guests waiting for clean rooms complain constantly to front desk employees. The front desk staff is frustrated with the slow pace at which the laundry processes guestrooms linen. The executive housekeeper and the staff laundry manager investigated and found that excessive wrinkling of linens led the staff to iron all sheets after the drying cycle. This was more than surprising because, just a few months ago, the hotel purchased and put into service a large quantity of no-iron linens. Attempting to quickly identify the cause of the wrinkling problem, the executive housekeeper gathered the laundry staff and asked three questions. Which of the following is not a question that would be asked to get to the bottom of the wrinkling problem?
- A.
Are sheets removed promptly from dryers and folded immediately?
- B.
Are washers and dryers overloaded with too many sheets any one time?
- C.
Are sheets dried for too long a time and at temperature thaty are too high?
- D.
Is oxygen bleach used in the wash cycle?
Correct Answer
D. Is oxygen bleach used in the wash cycle?Explanation
The question "Is oxygen bleach used in the wash cycle?" is not relevant to identifying the cause of the wrinkling problem. The issue at hand is excessive wrinkling of linens, which is causing delays in processing guestroom linen. The other three questions directly address potential causes for the wrinkling problem, such as the prompt removal and folding of sheets, overloading of washers and dryers, and the duration and temperature of the drying cycle. The use of oxygen bleach in the wash cycle does not directly relate to the wrinkling issue and therefore would not help in finding the cause.Rate this question:
-
- 4.
Poor soil removal is a problem at the Steadfast Hotel. The laundry crew wastes time and money rewashing several loads of wash a day. Which of the following would be the least likely cause of this problem?
- A.
Too litle detergent
- B.
Wash temperatures too low
- C.
Insufficient softners and sours
- D.
Overloading the washers
Correct Answer
C. Insufficient softners and soursExplanation
Insufficient softeners and sours would be the least likely cause of the problem because these substances are typically used to improve the softness and scent of the laundry, rather than to enhance soil removal. Therefore, if there is a problem with poor soil removal, it is unlikely to be caused by insufficient softeners and sours. The other options, such as too little detergent, wash temperatures too low, and overloading the washers, are more directly related to the effectiveness of soil removal and are therefore more likely to be the cause of the problem.Rate this question:
-
- 5.
Put the following steps in the proper order by numbering them from 1-5: Transfer
- A.
1
- B.
2
- C.
3
- D.
4
- E.
5
Correct Answer
E. 5 -
- 6.
Put the following steps in the proper order by numbering them from 1-5: Sorting
- A.
1
- B.
2
- C.
3
- D.
4
- E.
5
Correct Answer
B. 2 -
- 7.
When washing in a top-loader using liquid detergent, you should first fill with water, then add soap, then add clothes.
- A.
True
- B.
False
Correct Answer
A. TrueExplanation
This protocol from the past was meant to prevent residue on the fabric and the machine. But modern detergents are phosphate-free and not harmful to clothes the way old formulas were. As long as you're not using bleach, don't add clothing after the water (a pain, because clothes can float). Instead, use this order to distribute detergent best: clothes, then water, then soap.Rate this question:
-
- 8.
To reduce lint, add ½ cup _______ to the rinse cycle.
- A.
Distilled water
- B.
White vinegar
- C.
Tea-tree oil
- D.
Lime
Correct Answer
B. White vinegarExplanation
The acidity of white vinegar prevents lint from sticking to the fabric.Rate this question:
-
- 9.
What do these items have in common? A T-shirt with a transfer design, an embellished swimsuit, and dark jeans.
- A.
They should all be line-dried.
- B.
They should all be washed in cold water.
- C.
They should all be washed inside out.
- D.
None
Correct Answer
C. They should all be washed inside out.Explanation
Turning them inside out prevents fading and protects embellishments.Rate this question:
-
- 10.
It's best to let a dryer "rest" for an hour before putting in a new load.
- A.
True
- B.
False
Correct Answer
B. FalseExplanation
Running back-to-back dryer loads is smart and efficient. It lets you take advantage of retained heat from the previous cycle, cutting down on energy usageRate this question:
-
Quiz Review Timeline +
Our quizzes are rigorously reviewed, monitored and continuously updated by our expert board to maintain accuracy, relevance, and timeliness.
-
Current Version
-
Mar 22, 2022Quiz Edited by
ProProfs Editorial Team -
Oct 17, 2007Quiz Created by
Aoht
Back to top