FSG Rbq Shyam 4
Questions and Answers
- 1.
After testing ,If the driver makes a comment ,"The car pulls or wanders ", what could be the following cause?
- A.
Extreme front toe in or toe out
- B.
Failed pickup point
- C.
Damper with no control
- D.
All the above
Correct Answer
A. Extreme front toe in or toe outExplanation
If the driver makes a comment that "The car pulls or wanders," the following cause could be extreme front toe in or toe out. Toe in or toe out refers to the angle at which the front tires are pointing inwards or outwards. If the toe in or toe out is extreme, it can cause the car to pull or wander, as the tires are not aligned properly. This misalignment can result in uneven tire wear and affect the car's stability and handling.Rate this question:
-
- 2.
In the cost event,what is the penalty(points) for inaacurate fastener cost?
- A.
1
- B.
2
- C.
3
- D.
5
Correct Answer
A. 1Explanation
The penalty for inaccurate fastener cost in the cost event is 1 point.Rate this question:
-
- 3.
In the front bodywork,the nose must have forward facing radii of at least?
- A.
34mm
- B.
36mm
- C.
38mm
- D.
40mm
Correct Answer
C. 38mmExplanation
The correct answer is 38mm because the question is asking for the minimum forward facing radii of the nose in the front bodywork. This means that the nose must have a curvature with a radius of at least 38mm.Rate this question:
-
- 4.
To accommodate 5th to 95th percentile drivers,the teams must have a longitudinal adjustment in the head restraint of ?
- A.
100mm
- B.
120mm
- C.
140mm
- D.
No such requirement
Correct Answer
A. 100mmExplanation
The teams must have a longitudinal adjustment in the head restraint of 100mm to accommodate 5th to 95th percentile drivers. This adjustment allows the head restraint to be moved forward or backward to ensure that it is properly positioned for drivers of different heights. By having a 100mm adjustment, the teams can cater to a wide range of driver sizes and provide them with the necessary support and safety.Rate this question:
-
- 5.
The car number must be present in the car at a minimum of ___ locations
- A.
2
- B.
3
- C.
4
- D.
No such requirement
Correct Answer
B. 3Explanation
The car number must be present in the car at a minimum of 3 locations. This means that the car number should be displayed in at least three different places on the car. This could include locations such as the front and rear license plates, the windshield, and the side doors. Having the car number displayed in multiple locations helps with identification and can be useful for law enforcement or parking enforcement purposes.Rate this question:
-
- 6.
Competing in the accelaration event will give a minimum point of?
- A.
2.5
- B.
3.5
- C.
4.5
Correct Answer
B. 3.5Explanation
Competing in the acceleration event will give a minimum point of 3.5. This means that regardless of the performance, the participant will receive at least 3.5 points. It suggests that the event has a minimum score requirement or a guaranteed base score for all participants.Rate this question:
-
- 7.
A team obtained a design score of 132 points,but later the judges observed that the car has an old frame.Then the final score would be?
- A.
102
- B.
82
- C.
92
- D.
None
Correct Answer
A. 102Explanation
The team obtained a design score of 132 points, but since the judges observed that the car has an old frame, it is likely that they deducted points for this issue. Therefore, the final score would be lower than 132. Among the given options, the closest score to 132 after deducting points would be 102.Rate this question:
-
- 8.
What is the maximum height of the exhaust outlet from the ground?
- A.
50.8mm
- B.
50.8cm
- C.
60mm
- D.
60cm
Correct Answer
A. 50.8mmExplanation
The maximum height of the exhaust outlet from the ground is 50.8mm. This means that the distance from the ground to the exhaust outlet should not exceed 50.8mm.Rate this question:
-
- 9.
The maximum distance between the front hoop braces and the topmost surface of the front hoop is?
- A.
50.8mm
- B.
25.4mm
- C.
19mm
- D.
63.5mm
Correct Answer
A. 50.8mmExplanation
The maximum distance between the front hoop braces and the topmost surface of the front hoop is 50.8mm. This means that the front hoop braces can be positioned up to 50.8mm away from the topmost surface of the front hoop.Rate this question:
-
- 10.
If the number of members in a team is 25,then what will be the amount spent for registration?
- A.
850 euros
- B.
810 euros
- C.
870 euros
- D.
None
Correct Answer
A. 850 eurosExplanation
The amount spent for registration will be 850 euros. This can be inferred from the given information that the number of members in the team is 25. There is no additional information provided to calculate the exact amount spent for registration, so we can assume that the cost per member is 850 euros.Rate this question:
-
Quiz Review Timeline +
Our quizzes are rigorously reviewed, monitored and continuously updated by our expert board to maintain accuracy, relevance, and timeliness.
-
Current Version
-
Mar 21, 2023Quiz Edited by
ProProfs Editorial Team -
Jan 12, 2014Quiz Created by
Prvmarketing2014
Back to top