CCNA Exam Quizzes, Questions & Answers

Recent Quizzes

Select the correct choice for each of the following questions and score a perfect!

Questions: 21 | Attempts: 347 | Last updated: Mar 21, 2023

Sample Question
Why is IEEE 802.11 wireless technology able to transmit further distances than Bluetooth technology?

Transmits at much lower frequencies

Has higher power output

Transmits at much higher frequencies

Uses better encryption methods

It’s a good choice to have a certification of CCNA. It is important for one to learn CCNA if they are new at networking. This certification lasts for three years and can be renewed by taking a test before the...

Questions: 6 | Attempts: 183 | Last updated: Mar 20, 2023

Sample Question
What is Router?

Network Device

Car

Food

The Unbeatable Quiz On CCNA 1 Final Exam

The unbeatable quiz on CCNA 1 Final Exam

Do you thing that you have a proper understanding of all the topics that you covered at CCNA level 1? If you said a big yes to this then take up the totally unbeatable quiz below for the final exam and prove you are a genius...

Questions: 44 | Attempts: 5468 | Last updated: Aug 8, 2024

Sample Question
When connectionless protocols are implemented at the lower layers of the OSI model, what is usually used to acknowledge that the data was received and to request the retransmission of missing data?

IP

UDP

Ethernet

A connectionless acknowledgement

An upper-layer, connection-oriented protocol or service

CCNA Exploration V4 - Accessing The Wan - Exam Final Practice

CCNA Exploration v4 - Accessing the WAN - Exam Final Practice

Questions: 50 | Attempts: 209 | Last updated: Mar 21, 2023

Sample Question
A company is looking for a WAN solution to connect its headquarters site with four remote sites. What advantage would dedicated leased lines provide to the customer compared to a shared Frame Relay solution?

Lower cost

Lower latency and jitter

Variable bandwidth capacity

Fewer physical router interfaces

CCNA Exploration 3 - Final Exam

CCNA Exploration 3 - FINAL Exam

Your studies on the Exploration curriculum under the overarching Cisco Certified Network Associate have led you to this moment – it’s your final exam! Are you fully prepared to walk out with a certification that...

Questions: 52 | Attempts: 453 | Last updated: Mar 21, 2023

Sample Question
Refer to the exhibit. The network administrator needs to setup Switch1 for remote access from HostA. Theshow ip interface brief is issued on Router1 and the show interfaces trunk command is issued on theSwitch1 to verify the current status. The administrator applies the additional configuration shown in theexhibit to Switch1. However, the telnet from HostA fails. What additional commands need to be appliedto the switch?

A) Switch(config)# interface vlan 1 Switch(config-if)# ip address 10.1.1.250 255.255.255.0 Switch(config-if)# no shutdown Switch(config-if)# ip default-gateway 10.1.10.254

B)Switch(config)# interface vlan 1 Switch(config-if)# ip address 10.1.50.250 255.255.255.0 Switch(config-if)# no shutdown Switch(config-if)# ip default-gateway 10.1.50.254

C)Switch(config)# interface vlan 10 Switch(config-if)# ip address 10.1.10.250 255.255.255.0 Switch(config-if)# no shutdown Switch(config-if)# ip default-gateway 10.1.10.254

E)Switch(config)# interface vlan 50 Switch(config-if)# ip address 10.1.10.250 255.255.255.0 Switch(config-if)# no shutdown Switch(config-if)# ip default-gateway 10.1.10.254

E)Switch(config)# interface vlan 50 Switch(config-if)# ip address 10.1.10.250 255.255.255.0 Switch(config-if)# no shutdown Switch(config-if)# ip default-gateway 10.1.10.254

A Unique Quiz On Ccna4 Chapter 2

A Unique quiz on CCNA4 chapter 2

Welcome to a unique quiz which aims to boost some of your knowledge regarding your ongoing studies towards the Cisco Certified Network Associate – a certification which will ultimately allow you multiple career...

Questions: 20 | Attempts: 249 | Last updated: Mar 21, 2023

Sample Question
Which two statements are true about time-division multiplexing (TDM)? (Choose two.)

TDM relies on Layer 3 protocols to operate.

Multiple channels can transmit over a single link.

Original data streams must be reconstructed at the destination.

TDM methods vary depending on the Layer 2 protocol that is used.

It allows information from multiple channels to be allocated bandwidth on multiple wires.

CCNA 1 Chaper 5 Stimulated Quiz (By Foka)

CCNA 1 CHAPER 5 STIMULATED QUIZ (BY FOKA)

its a stimulated quiz of ccna 1 chapter 5 , i hope you like it

Questions: 21 | Attempts: 124 | Last updated: May 25, 2023

Sample Question
How large are IPv4 addresses?

8 bits

16 bits

32 bits

64 bits

128 bits

CCNA Module2 Pactice Quiz

CCNA module2 pactice quiz

The Cisco Certified Network Associate (CCNA) is a certification which offers a wide range of knowledge on the topic of networking, and as such gives students the opportunity to pursue an equally vast range of careers in the...

Questions: 47 | Attempts: 134 | Last updated: May 27, 2024

Sample Question
What are two functions of a router? (Choose two.)

It connects multiple IP networks.

It controls the flow of data via the use of Layer 2 addresses.

It determines the best path to send packets.

It manages the VLAN database.

It increases the size of the broadcast domain

CCNA 4 Final Exam The Best

ccna 4 final exam the best

If you are looking for the best CCNA final exam practice quiz then you just got lucky. The quiz below has the questions from the current syllabus. Give it a shot and see if you might need more reading time. All the best of...

Questions: 49 | Attempts: 508 | Last updated: Mar 22, 2023

Sample Question
Refer to the exhibit. The SSH connections between the remote user and the server are failing. The correct configuration of NAT has been verified. What is the most likely cause of the problem?

SSH is unable to pass through NAT.

There are incorrect access control list entries.

The access list has the incorrect port number for SSH.

The ip helper command is required on S0/0/0 to allow inbound connections.

The Candid Test On CCNA 4 Chapter 3

The candid test on ccna 4 chapter 3

The Connecting Networks course discusses the WAN technologies and network services required by converged applications in a complex network. This is what we covered in CCNA 4 chapter 3 and if you are looking for revision...

Questions: 14 | Attempts: 127 | Last updated: Jul 24, 2024

Sample Question
What is created between two DTEs in a Frame Relay network?

ISDN circuit

Limited access circuit

Switched parallel circuit

Virtual circuit

« Previous 1...5 6 7 8910 11 12 Next »